Welcome to URBA, a trusted name in microtunnelling

8 Tee Jay Terrace, Koolkhan NSW 2460

- VACUUM EXCAVATION -

Vacuum Excavation

Contact Us

Under Road Boring Australia runs its own vacuum excavation truck. It's on hand to support our trenchless crossings when a job needs it, and it's available for standalone hire. The truck uses high-pressure water and powerful suction to dig safely around live services and clear slurry, spoil and water from pits, without the risk of a bucket strike.

Get a QuoteCall Mick 0418 610 184
Under Road Boring Australia Isuzu vacuum excavation truck with VTI jetter combo body
10,000 LTipping spoil tank
4,000 LWater on board
3,000 psiExcavation water
150 mJetter hose reel
URBA vacuum excavation truck parked beside a launch shaft on a trenchless crossing
Our truck

Vac excavator and jetter in one

A 2020 Isuzu FYJ 300-350 fitted with a VTI (Vac Truck Industries) Goliath 10,000 L Jetter Combo body, built in 2021. It's a vacuum excavator and a high-pressure jetter in one unit: a 10,000 L tipping spoil tank, 4,000 L of water on board, a 3,000 psi excavation system and a 150 m jetter reel. One truck covers vacuum excavation, pit clean-out and jetting.

Blower discharge noise is rated at 80–84 dB at 7 m, which helps when planning work near homes and busy roads.

It's also available for standalone hire with an experienced URBA operator.

On-site support

Support on site when it's needed

On most large crossings, service locating and shaft excavation sit with the head contractor. Having our own vac truck means we can step in to help when it's needed, without waiting on another subcontractor.

Extra potholing when needed

If the alignment needs it, we can expose and confirm a service near the bore line on request.

Pit clean-out and spoil removal

Keeping launch and receival pits clear of slurry and spoil while the bore advances.

Pit dewatering

Pulling groundwater and rainwater out of pits and shafts so work can continue safely.

Jetting and cleaning casings

If required, we can flush steel casings and carrier pipes with the high-pressure jetter before grouting or handover.

Standalone hire

Vacuum excavation services

Potholing & service locating

Non-destructive excavation to expose gas, water, sewer, power, telco and fibre before you dig or bore.

Slurry & spoil removal

Drilling fluid, muddy water and loose spoil from pits, trenches and work areas.

Pit & trench cleaning

Cleaning out stormwater pits, valve pits, service pits and trenches.

Pipe & drain jetting

150 m of 1-inch jetting hose on a hydraulic reel for stormwater, sewer and culvert lines.

Wet hire with operator

Available wet hire with an experienced URBA operator. Call for rates and availability.

Talk to the Director

Every enquiry goes straight to Mick. Call 0418 610 184.

Specifications

Truck specifications

Chassis2020 Isuzu FYJ 300-350, Isuzu 6UZ1 six-cylinder diesel
BodyVTI Goliath 10,000 L Jetter Combo (built 2021)
WeightsGVM 31,000 kg · approx. tare 18,980 kg
Spoil tank10,000 L operating volume, hydraulic tipping with powered door open/close; sealed for travel by pneumatic valves
Tank ratingBuilt to AS1210-2010 Class 3, rated to full vacuum
Water4,000 L in two side saddle tanks
Vacuum systemJurop Helix 1200 air-injection blower, hydraulic drive, high/low settings, vacuum relief at -21 inHg (about -71 kPa)
Blower noise80–84 dB at 7 m (blower discharge)
FiltrationCyclone dropbox and bag house
Boom6" (150 mm) suction hose, fully hydraulic, 270° slew, extend/retract, raise/lower
Tank door inletBoom suction can be shut off to vacuum through the spoil tank door inlet instead
Excavation waterComet high-pressure pump, 32 L/min, system set at 3,000 psi, hydraulic drive
Hand lances25 m high-pressure hand reel; 1,500 mm and 2,100 mm stainless lances with swivel guns and turbo nozzles
JetterStainless Jurop hydraulic jetter reel, 150 m of 1-inch hose, hydraulic slew and spool with flow control, set at 1,900 psi
DriveSplit-shaft PTO driving the blower, hydraulics and water pump; 170 L hydraulic tank with thermo cooling fans
Controls & safetyTwo radio remotes plus base control box and boom pendant; emergency stops that shut down all functions; safety support bracket for tank lift and door
Why URBA

Why use our vac truck

One call

The bore and the vac truck come from the same company, so extra support can be arranged without bringing in another subcontractor.

Trenchless people

We know what a launch pit needs to keep a bore moving, because that's our core work.

Safety first

Non-destructive excavation around live services, run under our safe work method statements and plant risk assessments. Operators check for overhead powerlines before the boom is raised.

Family-owned & local

Based in Grafton NSW, working across Northern NSW and South East Queensland, with further travel by arrangement.

FAQ

Common questions

Do you do service locating on your boring jobs?

On most large crossings, service locating and shaft excavation sit with the head contractor. If extra potholing is needed near the bore line, our vac truck can help on request.

Can we hire the truck without a boring job?

Yes. The truck is available with an operator for standalone vacuum excavation, pit cleaning and jetting work.

What happens to the slurry and spoil?

Spoil is contained in the sealed 10,000 L tank for removal, and the tank is sealed for travel.

How deep can you dig?

Depth depends on ground conditions, access and the job. Call Mick on 0418 610 184 to talk it through.

Need a vac truck on your job?

Talk to the Director about your job. Call Mick on 0418 610 184 or email admin@urboring.com.au.

Get a Quote0418 610 184