Under Road Boring Australia runs its own vacuum excavation truck. It's on hand to support our trenchless crossings when a job needs it, and it's available for standalone hire. The truck uses high-pressure water and powerful suction to dig safely around live services and clear slurry, spoil and water from pits, without the risk of a bucket strike.
Get a QuoteCall Mick 0418 610 184
A 2020 Isuzu FYJ 300-350 fitted with a VTI (Vac Truck Industries) Goliath 10,000 L Jetter Combo body, built in 2021. It's a vacuum excavator and a high-pressure jetter in one unit: a 10,000 L tipping spoil tank, 4,000 L of water on board, a 3,000 psi excavation system and a 150 m jetter reel. One truck covers vacuum excavation, pit clean-out and jetting.
Blower discharge noise is rated at 80–84 dB at 7 m, which helps when planning work near homes and busy roads.
It's also available for standalone hire with an experienced URBA operator.
On most large crossings, service locating and shaft excavation sit with the head contractor. Having our own vac truck means we can step in to help when it's needed, without waiting on another subcontractor.
If the alignment needs it, we can expose and confirm a service near the bore line on request.
Keeping launch and receival pits clear of slurry and spoil while the bore advances.
Pulling groundwater and rainwater out of pits and shafts so work can continue safely.
If required, we can flush steel casings and carrier pipes with the high-pressure jetter before grouting or handover.
Non-destructive excavation to expose gas, water, sewer, power, telco and fibre before you dig or bore.
Drilling fluid, muddy water and loose spoil from pits, trenches and work areas.
Cleaning out stormwater pits, valve pits, service pits and trenches.
150 m of 1-inch jetting hose on a hydraulic reel for stormwater, sewer and culvert lines.
Available wet hire with an experienced URBA operator. Call for rates and availability.
Every enquiry goes straight to Mick. Call 0418 610 184.
| Chassis | 2020 Isuzu FYJ 300-350, Isuzu 6UZ1 six-cylinder diesel |
|---|---|
| Body | VTI Goliath 10,000 L Jetter Combo (built 2021) |
| Weights | GVM 31,000 kg · approx. tare 18,980 kg |
| Spoil tank | 10,000 L operating volume, hydraulic tipping with powered door open/close; sealed for travel by pneumatic valves |
| Tank rating | Built to AS1210-2010 Class 3, rated to full vacuum |
| Water | 4,000 L in two side saddle tanks |
| Vacuum system | Jurop Helix 1200 air-injection blower, hydraulic drive, high/low settings, vacuum relief at -21 inHg (about -71 kPa) |
| Blower noise | 80–84 dB at 7 m (blower discharge) |
| Filtration | Cyclone dropbox and bag house |
| Boom | 6" (150 mm) suction hose, fully hydraulic, 270° slew, extend/retract, raise/lower |
| Tank door inlet | Boom suction can be shut off to vacuum through the spoil tank door inlet instead |
| Excavation water | Comet high-pressure pump, 32 L/min, system set at 3,000 psi, hydraulic drive |
| Hand lances | 25 m high-pressure hand reel; 1,500 mm and 2,100 mm stainless lances with swivel guns and turbo nozzles |
| Jetter | Stainless Jurop hydraulic jetter reel, 150 m of 1-inch hose, hydraulic slew and spool with flow control, set at 1,900 psi |
| Drive | Split-shaft PTO driving the blower, hydraulics and water pump; 170 L hydraulic tank with thermo cooling fans |
| Controls & safety | Two radio remotes plus base control box and boom pendant; emergency stops that shut down all functions; safety support bracket for tank lift and door |
The bore and the vac truck come from the same company, so extra support can be arranged without bringing in another subcontractor.
We know what a launch pit needs to keep a bore moving, because that's our core work.
Non-destructive excavation around live services, run under our safe work method statements and plant risk assessments. Operators check for overhead powerlines before the boom is raised.
Based in Grafton NSW, working across Northern NSW and South East Queensland, with further travel by arrangement.
On most large crossings, service locating and shaft excavation sit with the head contractor. If extra potholing is needed near the bore line, our vac truck can help on request.
Yes. The truck is available with an operator for standalone vacuum excavation, pit cleaning and jetting work.
Spoil is contained in the sealed 10,000 L tank for removal, and the tank is sealed for travel.
Depth depends on ground conditions, access and the job. Call Mick on 0418 610 184 to talk it through.
Talk to the Director about your job. Call Mick on 0418 610 184 or email admin@urboring.com.au.
Get a Quote0418 610 184